I also purchased the Donkee. On low rpms it spins smoothly, but on high rpms has a good bit of wobble. Doesn't really bother me as I only use high rpm to polish, but I imagine it might annoy others. As others have said that the Vertex doesn't wobble I kinda wish I got that one. Live and learn.

I have a Vertex spinner, and depending on the ball orientation it will wobble also. Nothing I worry about though. It works quite well.

Well from the research I've done, the Vertex is spinning only around 435-450 rpm's. And the Donkee spins at 475 and 675 rpm's. And I've only heard that the Donkee wobbles at the higher speed. Sounds as if the Vertex might have some wobble depending on where the top weight is oriented at its one speed of 435+ rpm. So if the Vertex was capable of hitting the 675 rpm's that the Donkee is hitting it would most likely be a bad wobbler too. Donkee seems to be the only one with the splash guard, and I really don't have a $35+ need for a foot control pedal. So as soon as the Donkee's 3/4 hp are back in stock, I think this will be my choice.

i haven't found one for less $240.00 if someone has seen a ball spinner for $160.00 please give up the location. if someone has plans to build one i would like for them to share the plans with me. thanks

Brian-

Do you have a source for the different color 3M pads with reasonable prices?

Read

where can you get a spinner for $160.00?

I haven't seen any for $160. The least expensive I have found is $199, both Donkee and Vertex Mold have one for that price. I've never used any of those so can't say if they are any good, but I do believe in general you get what you pay for. If you aren't going to be using it but a few times a year, then an inexpensive spinner will probably be fine. If you are going to use it frequently spend the extra money and get a good, heavy duty spinner with a heavy metal base and metal ball cup. Then offer to your fellow bowlers to clean / sand / polish their balls for them for $3 or $5 to help offset the cost.

I totaly agree about getting what you pay for...
I have a motor and I think I can build one for a fraction of the price of a donkee and a vertex. If all works well I will post how I did it and all of us can enjoy the use of a good ball spinner.

I just made a spinner using a table top drill press. With some modifications the total cost was about $75.00. Variable speed and minimal wobble. Looks good and works great. Anybody want more info I can take pics.

That would be great!